Mitsubishi RS232/485/LAN Serial Communication Control Manual de usuario descargar pdf (Pagina 9)

4. eWON Serial Configuration

For simple serial communication, you need only

- to select the eWON port (COM1 for the serial port)

- to set the Port Type to “Raw TCP” (let the TCP port to its default value, 23)

- to configure the Line Parameters (BaudRate, Data, Parity, Stop bit and HW mode) to

match the serial port of your device.

In the above configuration, the device used is a Twido configured in RS485, then the

HW Mode is set to Half-Duplex and the Dipswitch is on RS485.

eVCOM (Standard serial communications) Page 9/29

IMPORTANT

The VCOM must be the only process using the Serial Port!

Then, you must disable all eWON IOServers using this serial port.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 28 29

Sin comentarios

Mitsubishi RS232/485/LAN Serial Communication Control Manual de usuario Pagina 9