Mitsubishi MOTION CONTROLLERS Q173DCPU Manual de instrucciones descargar pdf (Pagina 154)

4 - 9

4 INSTALLATION AND WIRING

(b) Removal

Push

Module fixing hook

END

Support the module with both

hands and securely press the

module fixing hook with your

finger.

Pull the module based on the

supporting point of module

bottom while pressing the

module fixing hook.

While lifting a module, take off

the module fixing projection

from the module fixing hole.

When using the module fixing

screws, remove them.

Lifting

Module

Base unit

Module

connector

Module fixing hole

Pull

POINT

When the module fixing screw is used, always remove the module by removing the

module fixing screw and then taking the module fixing projection off the module

fixing hole of the base unit.

Attempting to remove the module by force may damage the module fixing

projection.

CAUTION

Do not touch the heat radiating fins of controller or servo amplifier's, regenerative resistor and

servomotor, etc. while the power is ON and for a short time after the power is turned OFF. In

this timing, these parts become very hot and may lead to burns.

Remove the modules while paying attention.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 251 252

Sin comentarios

Mitsubishi MOTION CONTROLLERS Q173DCPU Manual de instrucciones Pagina 154